The motor uses injection molding, compared with the traditional 28 step motor, effectively reduce the thickness at the same time, simple structure, high assembly accuracy, low defect rate, no noise.
| STEP ANGLE | 1.8°±5% |
| NO. OF PHASES | 2 |
| RATED VOLTAGE | 1.4V |
| RATED CURRENT | 0.4A |
| RESISTANCE | 3.5 ohm±10% AT 25° |
| INDUCTANCE | 1.0 mH±20% AT 1kHz, 1Vrms |
| HOLDING TORQUE | 0.013 N.m(1.84 oz.in)TYP. |
| RUNNING TORQUE(AT --PPS) | --V.DC, --A/PHASE |
| DIELECTRIC STRENGTH | 500V A.C/MIN. |
| INSULATION RESISTANCE | 100MΩ+/MIN. |
| INSULATION CLASS | CLASS B |
| TEMPERATURE RISE | 80K MAX. |
| ROTOR INERTIA | 9 g.cm²(0.05 oz.in²) |
| WEIGHT | APPROX. 30g(1.06 oz) |
| ALLOWABLE THRUST LOAD | 10N |
| ALLOWABLE RADIAL LOAD | 21 N(ON THE SHAFT END) |
| OPERATION AMBIENT TEMP. | -20℃---+50℃ |
| OPERATION AMBIENT HUM. | 15%----90% |
| LIFE | 5000HOURS |
